How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask sprinkles08 Your Own Question
sprinkles08
sprinkles08, ASE Certified Technician
Category: UK Car
Satisfied Customers: 21602
Experience:  ASE Master and Advanced level certified. Factory trained with 15 years dealership experience
9825021
Type Your UK Car Question Here...
sprinkles08 is online now
A new question is answered every 9 seconds

I have a problem with my Mercedes vito w639 2.2 cdi 2005.

Customer Question

Hello, I have a problem with my Mercedes vito w639 2.2 cdi 2005. Run just 145000 km..
Automatic gearbox is in the limp mode.
Diagnostic tool - feil p0220 - speed sensor . I have changed electronic module in the gearbox and nothing changed. What else kan I do ?? Gearbox oil was clean before change and gearbox was working really fine..
Submitted: 1 year ago.
Category: UK Car
Customer: replied 1 year ago.
sorry diagnoistic toll showing fault P2200
Expert:  sprinkles08 replied 1 year ago.

Hello and welcome to JustAnswer!

P2200 is for the number 2 input speed sensor which is on the lead plate mounted to the top of the valve body. If the lead plate was replaced with a new part then you should be able to rule out the sensor itself.

If the sensor has been ruled out then it may be a mechanical failure in the trans, a wiring or connection issue, or it could possibly be the TCM.

Was the trans slipping at any point?

Customer: replied 12 months ago.
No it was not slipping at all , was like a dream. Where is the TCM in my Mercedes?
Expert:  sprinkles08 replied 12 months ago.

The TCM is inside the vehicle.

Do you have a scan tool to monitor data?

Customer: replied 12 months ago.
I have . Where in the vehicle ?
Customer: replied 12 months ago.
In the parameters scan tool is showing 0 rpm on the sensor 2 and 3 and then you can feel a bang sound and sensor read is 8000 and gearbox is in the limp mode now
Expert:  sprinkles08 replied 12 months ago.

Does it not show proper RPM at any time in any gear?

Customer: replied 12 months ago.
Exactly
Expert:  sprinkles08 replied 12 months ago.

Where did the replacement lead plate come from?

Customer: replied 12 months ago.
Finn.no kind of eBay in Norway. Was brand new orginal mercedes. But for few days ago I tried with the used one and exactly the same thing happened. I need to know where is TCM so I can check wiring
Expert:  sprinkles08 replied 12 months ago.

I'll get back to you as quickly as I can!