How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Billy Your Own Question
Billy
Billy, Trainer/Master tech.
Category: UK Car
Satisfied Customers: 3498
Experience:  Trainer - master tech., SAE member
30385560
Type Your UK Car Question Here...
Billy is online now
A new question is answered every 9 seconds

I have a problem camshaft intake sensor I changed a sensor

Customer Question

Hi
I have a problem camshaft intake sensor I changed a sensor and reset it with OBD2 tool after that check engine light come on and says comshaft intake sensor not working
Submitted: 1 year ago.
Category: UK Car
Expert:  Billy replied 1 year ago.
Hello and Welcome! I'm Billy and i will assist you with your inquiry. Feel free to ask if any further info is needed.
My apologies for the delay, thank you for your patience.
Can you get me the exact fault code you are getting?
do you have any other symptoms except the warning light and fault code?
Customer: replied 1 year ago.
HiCode is: 65 Signal Camshaft sensor intake
Expert:  Billy replied 1 year ago.
Hello,
Other than the code, is the engine behaving normally?
was the sensor wiring checked?
do you have any other problems or codes? (related to the timing, vanos etc..)?
And just to confirm, this is the one you replaced:
https://drive.google.com/file/d/0B6Zgf4dbmODzVUFHdVMzdi1CcEU/view?usp=sharing
Customer: replied 1 year ago.
Hi
One more fault code: 123 activate grid-controlled cooling and oil level lights come on on for 10 seconds after I start engine and hard to start engine and engine stalls when I driving
I did check wiring and I changed sensor which on the picture you sent me
Expert:  Billy replied 1 year ago.
Hello,
This seems to be getting a wider issue.
Having the oil warnings, i would start by draining the oil, removing the sump and checking the sump for gum build up, clean, and make sure you clean the pump inlet, then put new engine oil and filter.
This should take care of the oil issue (if you find gum in the sump, and if not, the oil level sensor would require checking.
Once we take care of that, we'll tackle the radiator flap (code 123).
Thank you for your trust! Get back to me if you need more assistance...Thank you in advance for the positive rating...
Regards,
Billy