How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Billy Your Own Question
Billy
Billy, Trainer/Master tech.
Category: UK Car
Satisfied Customers: 3498
Experience:  Trainer - master tech., SAE member
30385560
Type Your UK Car Question Here...
Billy is online now
A new question is answered every 9 seconds

Megane 2: . My upper brake light on my Renault Megane 2

Customer Question

Hi.
My upper brake light on my Renault Megane 2 doesn´t work. Do you have a scetch how to remove it?
Regards, Peter
Submitted: 1 year ago.
Category: UK Car
Customer: replied 1 year ago.
Renault Megane 2007 hatchback
Expert:  Billy replied 1 year ago.
Hello and Welcome! I'm Billy and i will assist you with your inquiry. Feel free to ask if any further info is needed.
I will attach the diagram and instructions, but make sure the connector is good upon refitting, as the connector might be the cause, it needs to have tight and clean contacts, here are the details:
https://drive.google.com/file/d/0B6Zgf4dbmODzZVRlb2dDUHZPcVk/view?usp=sharing
Thank you for your trust! Get back to me if you need more assistance...Thank you in advance for the positive rating...
Regards,
Billy
Customer: replied 1 year ago.
It's the wrong Megane.
Mine is the Megane 2 sport tourer.
So please send the right one.
Regards, Peter
Expert:  Billy replied 1 year ago.
Hello Peter,
The instructions are the same regarding the high level brake light.
Only the light part number changes, you need the light with part number:(###) ###-####
1. Unclip the tailgate upper trim
2. Unclip the light by pressing on the lugs with a flat-blade screwdriver.
3. Unclip the screen washer jet by pressing the clips.
4. Disconnect the connector, Remove the high level brake light.
PS: there is one screw, on the passneger side holding the light.
Regards,
Billy
Customer: replied 1 year ago.
Hi.
I can't "1. Unclip the tailgate upper trim
2. Unclip the light by pressing on the lugs with a flat-blade screwdriver."
since i can't see the light from the inside. I take the plastic cover away and there is metal covering the inside of the light.
So the picture is not the same as my car.
Expert:  Billy replied 1 year ago.
Hello Peter,
I'm afraid i don't have clearer instructions, but on the passenger side of the light, there should be a screw or bolt holding it from the inside, from this metal cover, do you see this screw?
Customer: replied 1 year ago.
No.
I attach two photos.
Expert:  Billy replied 1 year ago.
Hello Peter,
There are on the inside three round holes at light vicinity, the middle has a small hole under it, did you try inserting a screwdriver to reach and undo the one screw holding this light assembly?
Customer: replied 1 year ago.
Ahhhh.
Thank you. Found two screws.
I hope it's them.
Expert:  Billy replied 1 year ago.
You're most welcome Peter!
Just remove the light slowly (careful on the washer jet)... and check the connector before replacing with a new assembly (as the connector might cause this: it needs tight and clean contacts.
And again, the part number for this light is:(###) ###-####
Thank you for your trust! Get back to me if you need more assistance...Thank you in advance for the positive rating...
Regards,
Billy

Related UK Car Questions