How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Kevin Your Own Question
Kevin
Kevin, UK Car Mechanic
Category: UK Car
Satisfied Customers: 1435
Experience:  Diagnostic technician at vw /audi specialist
84635724
Type Your UK Car Question Here...
Kevin is online now
A new question is answered every 9 seconds

Corsa: customers vauxhall corsa C 1.0 5sp auto non start

Customer Question

customers vauxhall corsa C 1.0 5sp auto
non start has these faults logged and F on screen.
has been wiring repairs between bcu and tcm in the past
would like o be able to identify the wires that have been replaced to rule out bad repairs etc
P0560 - System voltage
- Malfunction
- Intermittent
U2106 - Transmission control module (TCM)
- no communication
- Permanent
P1700 - Service vehicle soon request from transmission control module
- Permanent
Multifunction (Central electronics - Body control module)
DTC Description
B1485 - Alternator excitation current, pin 61
- low voltage
B1424 - Power supply low before or on locking
B3796 - CDSL-motor
- Too high current
U2108 - CAN: No communication with ABS/TC
Submitted: 1 year ago.
Category: UK Car
Expert:  Kevin replied 1 year ago.
Hi I'm Kevin it's very common for engine ecu to fail on this model causing your faults. It fails internally and drops can lines between engine and gearbox and prevents car from starting
Customer: replied 1 year ago.

i asked for model specific wiring diagrams and information. i am not going to simply tell my customer that the ecu has failed on a common fault without verifying so first.

Expert:  Kevin replied 1 year ago.
Which specific diagrams would you like and il see what I have sorry I didn't realise you were a company most customers don't have the equiptment to test these items
Customer: replied 1 year ago.

Wiring and pin out from tcm, abs, tcs to the BCm. that's fine, I should have made that clear.

Expert:  Kevin replied 1 year ago.
This is for transmission
Expert:  Kevin replied 1 year ago.
This is can bus distribution
Expert:  Kevin replied 1 year ago.
This is engine layout
Expert:  Kevin replied 1 year ago.
These are the important key numbers from diagrams my system wont allow me to upload all of them if you need to know any ive missed let me know A11-multifunction control module(bcm)A16-ABS MODULEA35-ECMA5-dashA57-transmission control module
Customer: replied 1 year ago.

Please can you upload these in higher resolution. Can't read the small print!