Hello and thank you for allowing me to assist you with your problem. Here is that procedure for you. I hope this is helpful, and let me know if you need further assistance with this.
.Remove screws holding parking brake release handle to instrument panel.Remove screws holding bottom of lower steering column cover to instrument panel .Remove screw holding right side of lower steering column cover to instrument panel. .Disengage park brake release cable case from groove on end of release handle .Disengage cable end pivot from slot on release handle Park
.Remove the screws holding over steering column bezel to the cluster bezel .Disconnect the clips holding over column bezel to the cluster bezel. .If equipped with traction control switch, disconnect the wire pigtail connector from the traction control switch. .Remove the over steering column bezel from vehicle..Remove left end cover. .Remove screw at left end of cluster bezel and headlamp switch. .Remove screws holding cluster bezel to instrument panel from each side of steering column. Disconnect clip holding cluster bezel to instrument panel from above right vent louver. Separate cluster bezel from instrument pane Instrument Cluster Bezel l .Disconnect wire connectors from back of the bezel.