How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Daniel T. Your Own Question
Daniel T.
Daniel T., Home Appliance Technician
Category: UK Appliance
Satisfied Customers: 14668
Experience:  25+ yrs. experience in white goods repair. NVQ Level 2 electronics manufacturers training courses.
Type Your UK Appliance Question Here...
Daniel T. is online now
A new question is answered every 9 seconds

I have a bosch SGS53C02 dishwasher which seems to get stuck

Customer Question

Hi, I have a bosch SGS53C02 dishwasher which seems to get stuck on the final rinse cycle.
JA: Can you guesstimate how old your Bosch is? And just to clarify, what's the exact model?
Customer: It's 12 yes old and is a Classixx
JA: Do you plan on doing the work yourself?
Customer: Possibly
JA: Anything else we should know to help you best?
Customer: No?
Submitted: 1 month ago.
Category: UK Appliance
Expert:  Daniel T. replied 1 month ago.

Hi, I'm Daniel welcome to JustAnswer, Im reviewing your question now and will post back with your reply momentarily

Expert:  Daniel T. replied 1 month ago.

When you say it gets stuck on rinse is it just stopping completely?

Or does it just rinse forever untill you stop it?

Is it draining the water out?

Customer: replied 1 month ago.
It appears to be constantly trying to pump out despite it being empty.
Expert:  Daniel T. replied 1 month ago.

Ok if its constantly trying to pump all the time then its a water leak in the base thats activated the flood switch under there thats causing this fault.

What you need to do on this is pull the dishwasher out from under the unit and lie it on its back.

This will allow the water in the base to drain out so you will need a towel for this part.

Then stand it up right and this will reset the flood switch.

Retry it from there and hopefully this will get the dishwasher filling with water again.

If it does then fingers crossed its a one off overfill thats caused it and it should be fine from there. But if it happens again then you have a leak in there which you need to find and fix to cure the fault.

Customer: replied 1 month ago.
That didn't work! No water came out.
Expert:  Daniel T. replied 1 month ago.
Ok if no water came out and the dishwasher is still pumping all the time then you need to remove the left hand side panel.From there look in the bottom right corner and you will see a red plastic rod going down into the base.
Left this up and down a few times and then make sure it's in the down position and then see how it goes from there.As sometimes this can get stuck and This causes the pump to run all the time as well.But if that's all ok then the only this left here is the control board as that can fail and cause the pump to run all the time as well.

Related UK Appliance Questions