How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask George-Allsorts Your Own Question
George-Allsorts
George-Allsorts, Senior Appliance Technicial Manager
Category: UK Appliance
Satisfied Customers: 1448
Experience:  Senior Service & Technical Manager at Allsorts Recycling & Appliance Repairs
19471162
Type Your UK Appliance Question Here...
George-Allsorts is online now
A new question is answered every 9 seconds

Hotpoint aquarius fdw60 fastwash light is flashing, 7 years

Customer Question

hotpoint aquarius fdw60 fastwash light is flashing
JA: Can you guesstimate how old your Hotpoint is? And just to clarify, what's the exact model?
Customer: 7 years fdw60g
JA: Do you plan on doing the work yourself?
Customer: yes
JA: Anything else we should know to help you best?
Customer: no
Submitted: 4 months ago.
Category: UK Appliance
Expert:  George-Allsorts replied 4 months ago.

The fault is indicating an inlet valve fault.

Either the valve itself is defective, or there is no power to the valve.

Customer: replied 4 months ago.
I have already replaced the inlet valve. Water is entering the dishwasher when the program starts to run.
Expert:  George-Allsorts replied 4 months ago.

Is the water flow stopping at the correct level?

Customer: replied 4 months ago.
The water starts to fill and then after a few seconds the discharge pump starts.
Expert:  George-Allsorts replied 4 months ago.

Does the pump remain running or does it stop after a short while?

Customer: replied 4 months ago.
Pump remains running and water remains entering until you turn off power
Expert:  George-Allsorts replied 4 months ago.

Turn off the appliance and unplug it from the power socket.
Tilt the appliance backward at an angle of approx 60degs to see if water comes from the base and to expel any waters from the base if it exists.
If there is water, once it is expelled, turn the program on to check if it is working.

If the problem happens again thereafter then you'll need to remove the right-hand side panel to investigate for leaks.

Customer: replied 4 months ago.
No water in base of machine no leaks
Expert:  George-Allsorts replied 4 months ago.

Well then Check the heater and check the pressure switch.. If those two are ok then I would say you have an issue with your timer module