How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Daniel T. Your Own Question
Daniel T.
Daniel T., Home Appliance Technician
Category: UK Appliance
Satisfied Customers: 14830
Experience:  25+ yrs. experience in white goods repair. NVQ Level 2 electronics manufacturers training courses.
15468697
Type Your UK Appliance Question Here...
Daniel T. is online now
A new question is answered every 9 seconds

Filter light on Whirlpool AWZ3518. Have removed and cleaned

Customer Question

Filter light on Whirlpool AWZ3518. Have removed and cleaned filter. Is there a method to reset
JA: I'll do all I can to help. Tell me a bit more about what's going on so we can help you best.
Customer: Machine will not run while Filter alarm light is on
JA: Is there anything else the Appliance Technician should be aware of?
Customer: Not that I'm aware of
JA: OK. Got it. I'm sending you to a secure page on JustAnswer so you can place the $5 fully-refundable deposit now. While you're filling out that form, I'll tell the Appliance Technician about your situation and then connect you two.
Submitted: 5 months ago.
Category: UK Appliance
Expert:  Daniel T. replied 5 months ago.

Hi

To reset this you need to turn the dial to off.

Turn it to 6 oclock position.

Press reset button 3 times.

Turn dial 1 click clockwise

Press reset button 3 times again.

Then turn the dial to off.

Now turn it back on and see if this has reset the light. If not then you need to remove the back panel and from there you will see the heater and thermostats. Check the wiring on there as sometimes the wires can burn on the thermostat.

Try that and see what happens and let me know.

Regards