How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Daniel T. Your Own Question
Daniel T.
Daniel T., Home Appliance Technician
Category: UK Appliance
Satisfied Customers: 15001
Experience:  25+ yrs. experience in white goods repair. NVQ Level 2 electronics manufacturers training courses.
15468697
Type Your UK Appliance Question Here...
Daniel T. is online now
A new question is answered every 9 seconds

How do I replace a pub board on a becko dsc64w

Customer Question

How do I replace a pub board on a becko dsc64w
Submitted: 1 year ago.
Category: UK Appliance
Customer: replied 1 year ago.
It should be PCB, I have tried to reset the machine and it still won't start
Expert:  Daniel T. replied 1 year ago.

Hi

Sorry for the delay in getting to your question, Do you still need help on this?

Regards

Customer: replied 1 year ago.
please
Customer: replied 1 year ago.
I think this is the problem as I have tried to reset the machine by holding the buttons and as I said before the drum light is on
Expert:  Daniel T. replied 1 year ago.

Hi

Ok is the control board lights coming on still?

If not and its just the drum light that's on then this will be the control board. But what will have happened is the heater will have failed and blown the control board as well. So you need to replace the heater as well before fitting the new board as if you don't and you turn it on it will blow the new control board straight away.

To replace the control board you need to remove the top of the dryer and then pull out the water bottle.

Then remove the screws on the inside there.

Then you need to remove the screws o the very top if the control panel (if fitted). If no screws then its clips you need to push in to release the control panel and then you can replace the control board from there.

As to the heater this is located at the back behind the buldge cover there.

Regards