How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Daniel T. Your Own Question
Daniel T.
Daniel T., Home Appliance Technician
Category: UK Appliance
Satisfied Customers: 15156
Experience:  25+ yrs. experience in white goods repair. NVQ Level 2 electronics manufacturers training courses.
15468697
Type Your UK Appliance Question Here...
Daniel T. is online now
A new question is answered every 9 seconds

Beko wme8227B e18 fault tried reset but still no joy

Customer Question

beko wme8227B e18 fault tried reset but still no joy
Submitted: 1 year ago.
Category: UK Appliance
Expert:  Daniel T. replied 1 year ago.

Hi

Sorry for the delay in getting to your question.

What is the washer actually doing wrong for you?

Is it spinning?

Is it draining?

Is it filling with water and washing?

Regards

Customer: replied 1 year ago.
just stopped in mid program start indicator is flashing, machine now empty of washing on reset after all indicators come on, switching m/c off go's back to flashing start indication
Expert:  Daniel T. replied 1 year ago.

Hi

Ok E18 is an antibalance error code so its not really a fault as this wont cause the fault you have.

When it flashing the start light is the door locked so you cannot open it?

If so then you need to check the carbon brushes in the motor.

Pull the washer out and lean it bakwards against a wall and have some one hold it for you.

Then lie down and look under the washer and there you will see the back of the motor.

There either side are the carbon brushes. Take them out and see if they have worn down. If so then you need to replace them from there and finges crossed this sorts the washer out.

Check them and see what you find as worn carbpn brushes can cause faults like this you have now.

Let me know what you find.

Regards

Customer: replied 1 year ago.
Door is unlocked and can be opened, I will check carbon brushes tomorrow tho, to eliminate this possible cause
Expert:  Daniel T. replied 1 year ago.

Hi

Ok if the door isnt locking then forget about the carbon brushes.

You need to check the door lock. Remove the door lock and you need to test it with a multi meter. Theres 3 tags on the lock. Test between all 3 and you should get a reading between 2 of them. If you dont then the lock is the fault.

But if the lock is fine and it wont start and the door wont lock then the control board will be the fault here im afraid.

The carbon brushes are usually the fault where the washer wont start but the door locks so you cannot open it.

Regards