How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Daniel T. Your Own Question
Daniel T.
Daniel T., Home Appliance Technician
Category: UK Appliance
Satisfied Customers: 14668
Experience:  25+ yrs. experience in white goods repair. NVQ Level 2 electronics manufacturers training courses.
Type Your UK Appliance Question Here...
Daniel T. is online now
A new question is answered every 9 seconds

I have a Bosch logixx 7 washing machine (2 years old) En-r

This answer was rated:

I have a Bosch logixx 7 washing machine (2 years old)

When I run a cycle it stops with the drum about 1/4 full of water
The 'wash' red light and the 'rinse hold' red lights are both flashing

Hi, I'm Daniel and I'll be helping you today I've been repairing white goods for 20+ yrs. and currently work for a well-know manufacturer.


If you set the washer to a spin only cycle will it drain the water out then?



Customer: replied 3 years ago.
Hi there

Just tried it on the spin cycle and after 5 minutes it beeps a few times and the wash light and rinse hold lights are flashing again

Water still in the drum



Ok theres a blockage in there.


What you need to do is remove the wooden plyth at the bottom of the kitchen.

Then from there you will see the filter.

Get a thin try under there and slacken the filter and slowerly drain the water out.


Once the water is out remove the filter fully and give it a good clean out.

Make sure the pump impeller at the back inside were the filter goes is all clear.


Once clear refit the filter and retry the washer and see how it goes from there.


Let me know how it goes.



Daniel T. and other UK Appliance Specialists are ready to help you
Customer: replied 3 years ago.
Ok.... Just run the freshen up/ rinse cycle... And it seems to be working. Thank you!

Related UK Appliance Questions