How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Daniel T. Your Own Question
Daniel T.
Daniel T., Home Appliance Technician
Category: UK Appliance
Satisfied Customers: 14662
Experience:  25+ yrs. experience in white goods repair. NVQ Level 2 electronics manufacturers training courses.
Type Your UK Appliance Question Here...
Daniel T. is online now
A new question is answered every 9 seconds

hi,have hotpoint washdryer wdf740 ,over filled code f13 .select

Customer Question

hi,have hotpoint washdryer wdf740 ,over filled code f13 .select drain only ,pump ran for approx 2 seconds ,prog cancelled unable to select new prog.
Submitted: 4 years ago.
Category: UK Appliance
Expert:  Daniel T. replied 4 years ago.



F13 error code is a dryer NTC problem.


What you need to do is take off the top of the washer. From there you will see the dryer chamber on top. Towards the front of this is the NTC it will have 2 thin wires going to it.


Make sure the wires are on ok and not broken. If the wiring is fine then you will need a multimeter and test the NTC. It should give a reading in Kohms.


If the NTC is fine then its possible the control board at the back is the problem.


Im afraid on these washers if theres a fault anywere the washer just stops working and shows the error code untill its been repaired.



Related UK Appliance Questions