How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Daniel T. Your Own Question
Daniel T.
Daniel T., Home Appliance Technician
Category: UK Appliance
Satisfied Customers: 15355
Experience:  25+ yrs. experience in white goods repair. NVQ Level 2 electronics manufacturers training courses.
Type Your UK Appliance Question Here...
Daniel T. is online now
A new question is answered every 9 seconds

How do I change the drive belt on a Beko tumble dryer?

Customer Question

How do I change the drive belt on a Beko tumble dryer?
Submitted: 5 years ago.
Category: UK Appliance
Expert:  Daniel T. replied 5 years ago.


To change the belt you need to take the back cover off in the bottom right corner.

Then take all the screws off the back cover and pull it out a bit.

Then slid the belt down the front of the drum and around it.

Then refit the back cover.

Now slid the belt to the back of the drum so it lines up with the motor pully.

Now for the fun part. You need to strech the belt around the motor pully. I use a long screwdriver to do this.

Then once its on refit teh back cover and thats it job done.

But when the belt snapped was the drum stiff to turn?

If so then the front felt seal may be faulty as the glue from there comes off and causes the drum to stick and snappes the belt. If this is the case then the front felt seal will need to be replaced and drum cleaned up at the front.