How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask sprinkles08 Your Own Question
sprinkles08
sprinkles08, ASE Certified Technician
Category: Transmissions
Satisfied Customers: 22275
Experience:  Chrysler/Dodge/Jeep master tech ASE Master and Advanced Certified, Chrysler/Dodge/Jeep Master Certified, Trans Specialist
9825021
Type Your Transmissions Question Here...
sprinkles08 is online now
A new question is answered every 9 seconds

03 e320 know transmission codes but will shutdown can wait

Customer Question

03 e320 know transmission codes but will shutdown can wait and restart car move and shutdown again
JA: Have you scanned the code? Have you tried to reset it?
Customer: yes know codes
JA: What is the model/year of your Mercedes?
Customer: 03 e320
JA: What year is your Mercedes?
Customer: 2004
JA: Are you hoping to fix this yourself? What have you tried so far?
Customer: replace conductor plate ,torque conveter solenoid ,and pedal sensor
JA: Anything else you think the mechanic should know?
Customer: know codes in transmission moduel
JA: OK. Got it. I'm sending you to a secure page on JustAnswer so you can place the $5 fully-refundable deposit now. While you're filling out that form, I'll tell the Mercedes Mechanic about your situation and then connect you two.
Submitted: 10 months ago.
Category: Transmissions
Expert:  xsvectOR replied 10 months ago.

can you tell me the diagnostic trouble codes?

Customer: replied 10 months ago.
Po 122 i replaced the pedal sensor code never returned
Expert:  xsvectOR replied 10 months ago.

any tranny codes?

Customer: replied 10 months ago.
I put the car in drive it moves forward and reverse and then stop moving turn car off it resets know stored trans code
Customer: replied 10 months ago.
Using altel to clear codes
Customer: replied 10 months ago.
Ok
Expert:  sprinkles08 replied 10 months ago.

Hello and welcome to JustAnswer!

If the transmission engages for a period and then disengages, but engages again after a cooldown period that points to a restricted filter. The filter is most likely restricted with debris which could be from a clutch or geartrain failure or just from lack of periodic maintenance. It would be helpful to know what codes are setting, but the first thing that will need to be done based on these symptoms is remove the pan and inspect for clutch/geartrain debris, if there is no excessive debris then replacing the filter and fluid will likely take care of the issue.

Customer: replied 10 months ago.
Ok...will replace filter and there are know Transmission code showing up
Expert:  sprinkles08 replied 10 months ago.

Great!

Related Transmissions Questions