How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask cloe0626 Your Own Question
cloe0626
cloe0626, Auto Mechanic
Category: Transmissions
Satisfied Customers: 767
Experience:  was a mechanic in the army for four years and have been working at a dealer ship the past five years
74954164
Type Your Transmissions Question Here...
cloe0626 is online now
A new question is answered every 9 seconds

I have a 1999 infiniti g20 with manual transmission that I

Customer Question

i have a 1999 infiniti g20 with manual transmission that I just replaced. the old left side axle fits loose inside the new transmission. im trying to figure out what is going on. I ordered the two axles they offer for the base model and the touring and they are the same diameter.
Submitted: 1 year ago.
Category: Transmissions
Expert:  cloe0626 replied 1 year ago.

are you sure you are getting the axle lined up inside the transmission

Customer: replied 1 year ago.
the spline lines up and engaudges with the gear but fits loose by the bearing
Expert:  cloe0626 replied 1 year ago.

Line the splines of the axle up in the tranny and put it in as far as you can. Get a 18" long or so piece of 2x4. Let the hub side of the axle lay down a little and put the 2x4 against the tranny side CV joint. Using a hammer and the 2x4 like a nail and hit the axle into place. The sharp hits will usually seat it in 1-2 blow

Related Transmissions Questions