How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask sprinkles08 Your Own Question
sprinkles08
sprinkles08, ASE Certified Technician
Category: Transmissions
Satisfied Customers: 21604
Experience:  Chrysler/Dodge/Jeep master tech ASE Master and Advanced Certified, Chrysler/Dodge/Jeep Master Certified, Trans Specialist
9825021
Type Your Transmissions Question Here...
sprinkles08 is online now
A new question is answered every 9 seconds

Transmission in limp mode p0070 autostick sensor circuit

Customer Question

Transmission in limp mode p0070 autostick sensor circuit code
Submitted: 1 year ago.
Category: Transmissions
Expert:  sprinkles08 replied 1 year ago.
Hello and welcome to JustAnswer!
An autostick switch code can be caused by the shifter itself, wiring or a switch (depending on vehicle model) but an autostick issue shouldn't cause limp in since it isn't necessary for the trans to operate. If the solenoid pack has been replaced with one out of a working trans then the problem may be wiring, speed sensors, an internal TCM or trans issue.
P0700 sets in the engine controller when there is a code stored in the trans controller. Do you know what fault codes are setting in the TCM?
What model is the vehicle and which engine do you have?