How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask sprinkles08 Your Own Question
sprinkles08
sprinkles08, ASE Certified Technician
Category: Transmissions
Satisfied Customers: 21962
Experience:  Chrysler/Dodge/Jeep master tech ASE Master and Advanced Certified, Chrysler/Dodge/Jeep Master Certified, Trans Specialist
9825021
Type Your Transmissions Question Here...
sprinkles08 is online now
A new question is answered every 9 seconds

Xj: Wiring a 97 transmission into a 96 cherokee

Customer Question

Wiring a 97 transmission into a 96 cherokee need help with what wires go where

Submitted: 1 year ago.
Category: Transmissions
Expert:  sprinkles08 replied 1 year ago.
Hello and welcome to JustAnswer!

I'm showing 1993-2000 transmissions may be interchangeable.

You originally had and the replacement are both AW-4, correct?

What wiring difference are you seeing?
Customer: replied 1 year ago.

its actually 96 and a 98 my bad i just need the diagrams for both that so i can splice them togther here are the connectors96 xj connectors

Customer: replied 1 year ago.
Expert:  sprinkles08 replied 1 year ago.
Is that the range sensor connector?
Customer: replied 1 year ago.

yes,the 3 by 2 by 3 is the range from the 98 and the black one from the 96 is also the range.......the other 98 i believe is the siloniod control and same with the gray 96

Expert:  sprinkles08 replied 1 year ago.
The correct thing to do would be to swap the harness and the range sensor from the old trans. Were you not able to do this?
Customer: replied 1 year ago.

What about the wiring for the other sensor?

Expert:  sprinkles08 replied 1 year ago.
Which other sensor?
Customer: replied 1 year ago.

96 is on the left and 98 is on the right how am i supposed to splice them together. those are the sylinoid controlers

Expert:  sprinkles08 replied 1 year ago.
The wiring harness for the solenoids and speed senors should be swapped.
The range sensor should be swapped.
No splicing should be done.