How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Chris (aka-Moose) Your Own Question
Chris (aka-Moose)
Chris (aka-Moose), Auto Technician
Category: Toyota
Satisfied Customers: 814
Experience:  16 years of experience
2499435
Type Your Toyota Question Here...
Chris (aka-Moose) is online now
A new question is answered every 9 seconds

Ok 2003 toyota ehco 1.5 liter 5 speed 12 volts at batt engine

Customer Question

Ok 2003 toyota ehco 1.5 liter 5 speed 12 volts at batt engine light on and oil light on but no ignition power until i plug my scanner in then car powers up ignition starts and runs fine obd11 plug gets hot and when unplugged car shuts down and no ignition power again scanner puls up p0335 crank position sensor code ?? any ideas??
Submitted: 1 year ago.
Category: Toyota
Expert:  Ted Ritter replied 1 year ago.
Hello, thanks for postingI think what's happening is that the scanner/code reader is completing an open circuit possibly in the wiring between the Crank sensor and the ECM, have you measured the resistance of the sensor itself? If it shows about(###) ###-####ohms the sensor is not the problem and it's a wiring issue.