How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Ted Ritter Your Own Question
Ted Ritter
Ted Ritter, Toyota Master Tech
Category: Toyota
Satisfied Customers: 4183
Experience:  Toyota Master Tech, ASE Certified
1279120
Type Your Toyota Question Here...
Ted Ritter is online now
A new question is answered every 9 seconds

Camry Solara W TRD: Had numerous codes _O2 sensors,

Customer Question

Had numerous codes for AF _O2 sensors, lean etc. Replaced 2 AF sensors Bank 1 Sensor 1 Bank 2 Sensor 1 and Bank 1 Sensor 2. Now 3 codes remain as well as rough idle almost stalling. Present codes P1130 P 1150 P0171. 2000 Solara V6.
Submitted: 1 year ago.
Category: Toyota
Customer: replied 1 year ago.
Also cleaned throttle body after installation of sensors. Cleaned MAF before install.
Expert:  Ted Ritter replied 1 year ago.
Thanks for postingIt sounds like there may be an intake leak causing the lean condition which in turn causes the Air/fuel and O2 sensor codes, the sensors are reacting to the lean air/fuel mixture so the P0171 should be addressed first. Is there an exhaust leak? Have you checked for a possible intake leak that may let unmeasured air into the intake system?Does the engine idle smooth without misfires?Do you have a way to get fuel trim readings for both banks?
Customer: replied 1 year ago.
No misfires. Cannot get fuel trim readings either. There is an after market ingenuity cold air intake. Pulled off and reattached to make sure it was secure. What is your suggestion on how to locate an exhaust leak. The car has a 2nd generation TRD supercharger installed as well which makes it a little hard to hear any possible exhast leaks.
Expert:  Ted Ritter replied 1 year ago.
I think I'm going to have to opt out on this one, sorry.
Expert:  Ted Ritter replied 1 year ago.
Hopefully someone else can come up with a solution.
Customer: replied 1 year ago.
Decided to reclean the MAF sensor cleared codes. Drove about 30 miles. CEL back on with 3 different codes. P0125 P1135 P1155- all seem to point to AF sensor. Could it be I have a faulty AF sensor (just installed), or MAF sensor or could it possibly be an exhaust leak that is undetected.
Expert:  Ted Ritter replied 1 year ago.
Ok, thanks for the reply, those codes are for the a/f sensor bank one sensor one which is located in the exhaust near the firewall, this the #1 sensor that should be replaced. If you already replaced it try another one and use the Denso brand which is the same Toyota uses
Customer: replied 1 year ago.
Already replaced it again as well as front bank 2 sensor. Both Densos. This was done when we recleaned MAF in previous response

Related Toyota Questions