How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Skyvisions Your Own Question
Skyvisions
Skyvisions, ASE Certified Technician
Category: Toyota
Satisfied Customers: 14410
Experience:  Toyota Master Diagnostic
8257649
Type Your Toyota Question Here...
Skyvisions is online now
A new question is answered every 9 seconds

On a 1993 toyota camry 4 cylinder engine, the oil filter housing/oil

This answer was rated:

On a 1993 toyota camry 4 cylinder engine, the oil filter housing/oil cooling unit is attached to the engine block with a long pipe with a 30mm nut as integral part. To loosing this nut/pipe took an impact wrench since it was so tight. A 3 foot cheater bar would not budge it. So what is the tightening torque spec?
Thank you for choosing JustAnswer and allowing me to help you resolve your Toyota questions! Standby while I look that info up.
Make sure you replace the Oring.

Torque: 78 N-m (800 kgf-cm, 58 ft-lbf)

Skyvisions and 4 other Toyota Specialists are ready to help you
Customer: replied 3 years ago.

Thanks. Yes I have a new Oring (90301-52006) on a oil cooler gasket (15785-35010)

Good. They are known to leak and yes they are a pain to break loose. Do not know why they are so tight.