How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Skyvisions Your Own Question
Skyvisions
Skyvisions, ASE Certified Technician
Category: Toyota
Satisfied Customers: 14354
Experience:  Toyota Master Diagnostic
8257649
Type Your Toyota Question Here...
Skyvisions is online now
A new question is answered every 9 seconds

how to remove an oil filter on 2007 Toyota Sienna?

Resolved Question:

how to remove an oil filter on 2007 Toyota Sienna?
Submitted: 4 years ago.
Category: Toyota
Expert:  Skyvisions replied 4 years ago.

Thank you for choosing JustAnswer and allowing me to help you resolve your Toyota questions!

Which engine do you have in this vehicle the 3.3 L or the 3.5 L?

Customer: replied 4 years ago.
3.5L
Expert:  Skyvisions replied 4 years ago.
On this particular engine the oil filter is a paper cartridge type filter. You need a filter Wrench that goes over the end of the filter housing located on the right front corner of the engine compartment area from underneath the vehicle. Hopefully the last person that installed the filter/housing did not over tighten it or it can be a bear to get off. The new filter should come with a new O-ring. You do not have to remove the little Alan Screw in the end of the housing that is strictly to drain the filter and if you have a large drain pan you can just remove the entire housing and remove the filter and O-ring.
Skyvisions and 2 other Toyota Specialists are ready to help you

Related Toyota Questions