How can I wire from engine compartment to driver's side to install fog lamp wires for interior fog lamp switch on 2009 Toyota Camry Hybrid? Is there a ready made access hole? Need a 5/8" diam hole.
Country: United StatesMake: ToyotaModel: Camry HybridYear: 2009 Already Tried: Best place so far is to drill hole thru plastic housing at cabin air intake on passenger side by cabin air filter.
since Toyota uses the Main Harness when installed from factory, you have to make or find you own access holeI use the Hood Release Cable Firewall Grommet to run wiresPull back grommet & put a hole into it, or leave grommet & pierce hole under dashRun a long stiff pull wire thru & attach Fog Lamp wire & pull thru
Your DEPOSIT is not payment
I have sent the information you have requested & have answered .If you have more questions about a different problem or area, it is considered to be "additional" & may have to Relist.
PLEASE click ACCEPT on your page, so that I may get credit for my Answer at this time, thanks.
Even if you are a subscription or trial member you must click "Accept" for me to be paid
Experience: Heavy Line Mech-, Mobile Electronics. Sales, Installation & Repair for 30 years. R/S, etc.