How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask scionking Your Own Question
scionking
scionking, Toyota Expert
Category: Toyota
Satisfied Customers: 469
Experience:  5 YRS EXP. ASE MASTER CERTIFIED/ TOYOTA MASTER CERTIFIED
26789525
Type Your Toyota Question Here...
scionking is online now
A new question is answered every 9 seconds

2002 2.4: CAMRY..TOYOTA..CRANKSHAFT..NO TIMING MARKS ON THE CRANK GEAR

Resolved Question:

2002 2.4 CAMRY, WHEN INSTALLING THE BALANCE SHAFTS, TOYOTA SHOP MANUEL DOSE NOT SAY THE LOCATION THAT THE CRANKSHAFT SHOULD BE. MY GUSS IS TOP DEAD CENTER # XXXXX CYLINDER. THERE ARE NO TIMING MARKS ON THE CRANK GEAR FOR THE BALANCE SHAFTS TO LINE UP WITH. I DO HAVE THE DIAGRAM FOR THE BALANCE SHAFTS GEAR TO GEAR\SHAFT MARKINGS
Submitted: 5 years ago.
Category: Toyota
Expert:  scionking replied 5 years ago.
What toyota states is that number 1 crank pin has to be at 6 oclock, this is with engine upside down on engine stand, so at Tdc for number 1 cylinder the crank pin is at 6'oclock.
So Tdc engine on number 1 cylinder then install gears, no line up marks on the crank gear.
scionking and 2 other Toyota Specialists are ready to help you

Related Toyota Questions