how to replace sepentine belt on a 2007 toyota yaris
Country: United StatesMake: ToyotaModel: YarisYear: 2007
loosened alternator, belt seems too short. is there something else to loosen?
Greetings and welcome to just answer!!!!!1
are you there?
Yes i am here.
Did you loosen bot alternator bolts or just 1?
Sorry I meant Both.
Do you have the old belt off?
my daugherter was driving the car, it came off and was lost
what is the part number for the new one? Does it have ac?
Dayco XXXXXXX, it has ac
Give me just a second to look
That is the correct part number. do you have the top adjustment all the way over?
are you talking about the alternator, am i routing the belt wrong?
Yes I am talking about the alternator.
I see your image, it is routed correctly, I've replaced belts before, I am doing something wrong.
Unless the belt is defective and not long enough. Is the same # XXXXXXX on the belt, I have seen the wrong belt in the sleeve.
Alternator is loose and appears it must be pushed toward the engine for the most ease in installing
Yes that would be correct.
Is it even close to going on? Is the # XX the belt?
let me check if you can wait a few min
No problem I am here!
it is correct, you have done all you can do. thank you
No problem Good luck. If you can get it close sometimes you can bump Them on.
my email is XXXXX@XXXXXX.XXX i cannot come up with a password XXXX will work, computer crash, all data lost
I can only correspond through just answer! Just come back to this thread to get to me.
Shop Manager with 25 years experience
What Happens Now?Your chat has ended, but you can still work with your Expert to get an answer to your question if you have not yet received one.Come back to this page at any time to see additional information from your Expert. You will also receive an email when your question is updated. If you want to send a message to your Expert, use the box below.If you have already received a satisfactory answer to your question, click the Accept button above. Experts are credited for each accepted answer they provide.
I am very pleased to have helped you - Please click the Accept button for me now - Thank You ...and if you do need or wish to get back to me after - you can do so just by coming back to this post and use the Reply button - your reply will then come straight back to me .. and I am always happy to help further, Bob