How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask stone314 Your Own Question
stone314
stone314, degree
Category: Toyota
Satisfied Customers: 70
Experience:  Automotive Degree
33389813
Type Your Toyota Question Here...
stone314 is online now
A new question is answered every 9 seconds

2006 corolla: the light on the automatic gear shift..models

This answer was rated:

How do you replace the light on the automatic gear shift of a 2006 corolla. It is not the same as earlier models that I have seen how to change.
good afternoon thank you for using Just Answer.com what size is your engine?
Customer: replied 6 years ago.
Where would I find that information because I really do not know.

FLOOR SHIFT ASSEMBLY (A245E)




COMPONENTS

OVERHAUL

  1. REMOVE CONSOLE PANEL UPPER
  2. REMOVE CONSOLE BOX CARPET
  3. REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY
  4. REMOVE CONSOLE BOX SUB-ASSEMBLY REAR

  1. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
    1. Remove the cable end from the rod of the floor shift assembly.

    1. Using a screwdriver, disconnect the control cable from the shift lever plate. HINT: Tape up the screwdriver tip before use.

  1. DISCONNECT FLOOR SHIFT PARKING LOCK CABLE ASSEMBLY
    1. Remove the cable end from the lever pin of the floor shift assembly.

    1. Using a screwdriver, disconnect the parking lock cable from the floor shift assembly. HINT: Tape up the screwdriver tip before use.
  1. REMOVE FLOOR SHIFT ASSEMBLY
    1. Disconnect the 2 connectors.

    1. Disconnect the 2 wire harness clamps from the shift lever assembly.
    2. Remove the 4 bolts and floor shift assembly.

  1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
    1. Releasing the lock by pressing the slick, disconnect the indicator lamp wire connector from the shift lever plate.

    1. Disengage the secondary locking device.
    2. Using a small screwdriver, disengage the locking lug of the terminals 2 and 4, and pull the terminals out from the rear.
    3. Disconnect the wire harness from the clamps.

    1. Remove the 2 screws and shift lever knob sub-assembly. NOTICE: Pay attention not to apply unnatural load to transmission control switch wire harness.

  1. REMOVE FLOOR SHIFT SHIFT LEVER KNOB COVER
    1. Remove the shift lever knob cover.

  1. REMOVE TRANSMISSION CONTROL SWITCH
    1. Using a small screwdriver, remove the transmission control switch. HINT: Tape up the screwdriver tip before use.

  1. REMOVE SHIFT LEVER KNOB BUTTON
    1. Remove the shift lever knob button and spring.

  1. REMOVE INDICATOR LAMP WIRE SUB-ASSEMBLY
    1. Remove the indicator lamp wire sub-assembly.
    2. Remove the cap and bulb from the indicator lamp wire sub-assembly.

stone314 and 2 other Toyota Specialists are ready to help you

Related Toyota Questions