How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Genchi Genbutsu Your Own Question
Genchi Genbutsu
Genchi Genbutsu, Toyota Master Technician
Category: Toyota
Satisfied Customers: 4387
Experience:  Toyota Certified Master Diagnostic Technician, ASE Master Technician with L1 Advanced Engine
17930070
Type Your Toyota Question Here...
Genchi Genbutsu is online now
A new question is answered every 9 seconds

How to replace passenger side mirror on 2006 Prius

Customer Question

How to replace passenger side mirror on 2006 Prius?
Submitted: 6 years ago.
Category: Toyota
Expert:  Genchi Genbutsu replied 6 years ago.

DISASSEMBLY

HINT:

  • Use the same procedures for the LH side and RH side.
  • The procedures listed below are for the LH side.

 

1. REMOVE NO. 2 REAR FLOOR BOARD

2. REMOVE REAR DECK FLOOR BOX

3. REMOVE NO. 3 REAR FLOOR BOARD ASSEMBLY

4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

5. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH



(a) Using a screwdriver, detach the 2 clips and remove the garnish.

HINT:

Tape the screwdriver tip before use.

6. REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH



(a) Using a screwdriver, detach the 3 claws and remove the bezel.

HINT:

Tape the screwdriver tip before use.

7. REMOVE DOOR PULL HANDLE



(a) Remove the screw and pull handle.

8. REMOVE FRONT DOOR ARMREST UPPER BASE PANEL LH



(a) Driver's side:

Using a screwdriver, detach the 2 clips and 4 claws, and remove the armrest base panel together with the window regulator master switch.

HINT:

Tape the screwdriver tip before use.

(b) Disconnect the switch connector.

(c) Remove the 3 screws and the window regulator master switch from the armrest base panel.



(d) Passenger's side:

Using a screwdriver, detach the 2 clips and 4 claws, and remove the armrest base panel together with the 2 switches.

HINT:

Tape the screwdriver tip before use.

(e) Disconnect the switch connector.

(f) Using a screwdriver, detach the 2 claws and remove the door control switch.

HINT:

Tape the screwdriver tip before use.

(g) Using a screwdriver, detach the 2 claws and remove the power window regulator switch.

HINT:

Tape the screwdriver tip before use.

9. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH



(a) Remove the screw.

(b) Using a screwdriver, detach the 7 clips and remove the trim board.

HINT:

  • Tape the screwdriver tip before use.
  • In order to prevent the door panel from being damaged, use protective tape to cover the areas indicated by the arrow marks in the illustration.
  • If the clip cannot be reached with the screwdriver, pull on the lower trim to remove it.

You will also need to remove the door panel.....

Customer: replied 6 years ago.
Relist: Incomplete answer.

Related Toyota Questions