How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask marcpod Your Own Question
marcpod, Own collision repair advice
Category: Toyota
Satisfied Customers: 2881
Experience:  i-car/ASE/Basf training, 300 repairs and 650,000 in Collision w 18 yrs exp licensed adjuster
Type Your Toyota Question Here...
marcpod is online now
A new question is answered every 9 seconds

How do i fix an oil pan gasket leak in a 93 toyota pickup truck.

Customer Question

how do i fix an oil pan gasket leak in a 93 toyota pickup truck.
Submitted: 7 years ago.
Category: Toyota
Expert:  marcpod replied 7 years ago.

welcome to just answer. You should take oil pan off and put new oil pan gasket on. Here are the directions. If you accept his please hit the payment tab. thank you.

Service and Repair


  1. Remove engine undercover.
  2. Drain engine oil into a suitable container.
  3. Remove the engine mounting bolts. 2WD: Place jack under the transmission and raise engine approx. 25 mm (0.98 in.)
  4. Remove the 16 bolts and 2 nuts.
  5. Using SST 09032-00100 or equivalent, separate the oil pan from the cylinder block.
NOTE:When removing the oil pan, be careful not to damage the oil pan flange.


  1. Remove all old packing material and be careful not to drop any oil on the contacting surfaces of the oil pan and cylinder block.
    1. Using a razor blade and gasket scraper, remove all the packing (FIPG) material from the gasket surfaces.
    2. Thoroughly clean all components to remove all of the loose material.
    3. Clean both sealing surfaces with a non-residue solvent.
NOTE:Do not use a solvent which will affect painted surfaces.
  1. Apply seal packing to the joint part of the cylinder block and chain cover, cylinder block, and rear oil seal retainer.

Seal Packing Locations

Seal packing: Toyota Part No. 08826-00080 or equivalent

Oil Pan Sealer Application

  1. Apply seal packing to the oil pan as shown in the image. Install a nozzle on the tube that has been cut to a 5 mm (0.20 in) opening. NOTE: Avoid applying an excess amount to the surface. Be especially careful near oil passages.
    1. Parts must be assembled within 5 minutes of application. Otherwise, the material must be removed and re-applied. Immediately remove nozzle from tube and reinstall cap.
  1. Install the oil pan over the studs on the block with 16 bolts and 2 nuts. Torque the bolts and nuts to 12 N.m (9 ft. lb) .
  2. Install the engine under cover.
  3. Wait 30 minutes before adding engine oil into crankcase.
  4. Add enough engine oil to the FULL mark on the dipstick tube.


Related Toyota Questions