How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask tamaz Your Own Question
tamaz
tamaz, Subaru master technician
Category: Subaru
Satisfied Customers: 1167
Experience:  Subaru certified,ASE Master technician,25 years experience
70031029
Type Your Subaru Question Here...
tamaz is online now
A new question is answered every 9 seconds

I have a 2011 outback. the brake light blinks, the ABS light

Customer Question

i have a 2011 outback. the brake light blinks, the ABS light is on and the VDC light is on. it has a code C0234,and a code C0052. The VDC Control has been changed, the brake light bulbs are correct. The bat cable ends have been changed. The connection at the computer has been checked. any suggestions
Submitted: 11 months ago.
Category: Subaru
Expert:  tamaz replied 11 months ago.

Hi,the ABS control module needs to be programmed by the dealer before it can be used do you know if this was done yet

Customer: replied 11 months ago.
that has been done
Expert:  tamaz replied 11 months ago.

Hi ,has the fuse link in the main fuse box been checked it's a 50 amp link that allows power flow

Customer: replied 11 months ago.
Fuse is good
Expert:  tamaz replied 11 months ago.

So,was this vehicle involved in any type of accident where wiring may have been damaged

Expert:  tamaz replied 11 months ago.

Just looking for a little back ground,normally we see broken wiring, blown fuse etc...modules are a rarity unless the vehicle was tagged in right front

Customer: replied 11 months ago.
Never been in any accidents
Expert:  tamaz replied 11 months ago.

Let me research the wiring diagram to give you some ideas,be back soon

Customer: replied 11 months ago.
I also pulled the starter bolt cleaned it with Emery cloth. Cleaned the ground wire also. Also cleaned the ground by the fuse box. Pulled the connector at the computer it looks good but I did not pin check it.
Expert:  tamaz replied 11 months ago.

the next step is seeing if you have battery voltage at pin 1 and 7 looking now for wire color

Expert:  tamaz replied 11 months ago.

Pin1 red/white battery voltage pin 7 green /yellow battery voltage pin 14 red/yellow also battery voltage

Customer: replied 11 months ago.
OK but I'm done for the night
Expert:  tamaz replied 11 months ago.

no problem , i'll be on tomorrow night ,thanks