How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask brownjeff Your Own Question
brownjeff
brownjeff, ASE Certified Technician
Category: Subaru
Satisfied Customers: 13886
Experience:  17 years experience, ASE certified, dealership certified, Service Manager for 15 years,
11021861
Type Your Subaru Question Here...
brownjeff is online now
A new question is answered every 9 seconds

Subaru FORRESTER HOW TO CHANGE AUTOMATIC TRANSMISSION FLUID

This answer was rated:

HOW TO CHANGE AUTOMATIC TRANSMISSION FLUID IN 2005 SUBARU FORRESTER
Hello and Welcome to JustAnswer,

My name is XXXXX XXXXX I am here to try and assist your with your question.

REPLACEMENT

  1. Lift-up the vehicle.
  2. Drain the ATF completely.
CAUTION: Directly after the engine has been running, the ATF is hot. Be careful not to burn yourself.

graphic

  1. Replace with a new gasket, and then tighten the drain plug (ATF). Tightening torque: 25 Nm (2.5 kgf-m, 18.1 ft. lbs.)
  2. Lower the vehicle.
  3. Pour ATF from the ATF charge pipe. Recommended fluid: Dexron III type automatic transmission fluid

Capacity: Fill the same amount of ATF drained from drain plug hole.
Capacity when transmission is overhauled: 9.3 - 9.6 liters (9.8 - 10.1 US quarts, 8.2 - 8.4 Imp quarts)

  1. Check the level and leaks of ATF.
  2. Bleed the air of control valve.
  3. Check the level and leaks of ATF.
brownjeff and 3 other Subaru Specialists are ready to help you

Related Subaru Questions