Small Engine Troubleshooting Problems? Ask a Mechanic Now.
Hi I'm Wayne
I will help you with this
you are not going to like this answer
you need to cut it off, it is pressed on
use a air die grinder, or a little Dremel bit in a drill
I hope this helped you
Hi. If this helped you,
Please remember to rate my answer 3 or more stars.
I do not get paid for question, unless you rate my answer
If more info is needed, use the reply button -
NOT THE POOR/BAD SERVICE
Yes it is a bad design..........
remove that center bolt and yes you will destroy the impeller
but you are installing a new one
silicone the shaft and heat the impeller with a hair drier to push on