How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Wayne Your Own Question
Wayne
Wayne, Engine Rebuilder
Category: Small Engine
Satisfied Customers: 9332
Experience:  many years on egine rebuilding, lawn mower,roto tiller,Truck,and small engines
6825259
Type Your Small Engine Question Here...
Wayne is online now
A new question is answered every 9 seconds

Our Toro Clear 621E won't start even with the extension cord

Customer Question

Our Toro Clear 621E won't start even with the extension cord plugged to a power source. I tried the recoil starter and the electric starter button but no luck. I put in new gas on the machine yesterday. I have the choke on and primed before starting. It will start to run for about 5 seconds but will stop. It looks like the machine is only burning the primed gas and no gas is actually going in.
JA: Do you have fuel in the tank? If so, is the shut-off valve open and the fuel clean?
Customer: I put in new gas yesterday. The fuel is clean. Where is the shut off valve?
JA: Do you plan on doing the work yourself?
Customer: What has to be done?
JA: Anything else we should know to help you best?
Customer: I have given you all I know and what I've done to make it start.
Submitted: 7 months ago.
Category: Small Engine
Expert:  Wayne replied 7 months ago.

Hi I'm Wayne

I will help you with this

was this stored with gas in it ??

Customer: replied 7 months ago.
Nope. There is no gas when I put in new gas yesterday.
Expert:  Wayne replied 7 months ago.

Thank you for that

Ok, what your issue is the needle valve is stuck

remove the gas bowl, and move the float up/down

and make sure the needle valve hooked to float is moving

I hope this helped you

Hi. If this helped you,

Please remember to rate my answer 3 or more stars.

I do not get paid for question, unless you rate my answer

If more info is needed, use the reply button -

NOT THE POOR/BAD SERVICE

Customer: replied 7 months ago.
Hello Wayne,Thank you for your direction. I will try the procedure later since I am still working on something right now. I will provide rating then.Victor Medalle
Expert:  Wayne replied 7 months ago.

OK,

Thank you

Expert:  Wayne replied 7 months ago.

Morning

Just a follow up with you

did my answer help you

Let me know, Please

Wayne