How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Wayne Your Own Question
Wayne
Wayne, Engine Rebuilder
Category: Small Engine
Satisfied Customers: 8430
Experience:  many years on egine rebuilding, lawn mower,roto tiller,Truck,and small engines
6825259
Type Your Small Engine Question Here...
Wayne is online now
A new question is answered every 9 seconds

2.6L Generac (Propane) 3Phase 105A 250V Xfer-SW. stopped

Customer Question

2.6L Generac (Propane) 3Phase 105A 250V Xfer-SW. stopped generating, checked the voltage at the brushes it was low, Replaced the (obsolete?) Voltage regulator 67680 and new style wiring harness. Start up should have all the led's lit, but are not, could only find one fuse on the PC board. Without tearing all the wiring apart to trace the wires can you tell me where there might be more fuses? and/or more trouble shooting advice.
Submitted: 1 month ago.
Category: Small Engine
Expert:  Wayne replied 1 month ago.

Hi I'm Wayne

I will help you with this

what is the complete model number of the genset

Customer: replied 1 month ago.
where is the model # located?
Customer: replied 1 month ago.
Does SG030 sound right? (30KW 60Hz) I found this number in some documents with the set. Not off the generator itself , but it looks like the same unit.
Expert:  Wayne replied 1 month ago.

Thank you for that

yes the model is SG 030

it has 1 fuse on the panel board 7.5 Amp

Customer: replied 1 month ago.
Well that fuse is good so is there any other place to look for more fuses? what pins should have the voltages to power up the voltage regulator
Expert:  Wayne replied 1 month ago.

Hi

I can not help you any more

my knowledge is limited to that model

I will opt-out, and put back to board for another expert

sorry I could not help you