How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Wayne Your Own Question
Wayne
Wayne, Engine Rebuilder
Category: Small Engine
Satisfied Customers: 8429
Experience:  many years on egine rebuilding, lawn mower,roto tiller,Truck,and small engines
6825259
Type Your Small Engine Question Here...
Wayne is online now
A new question is answered every 9 seconds

Have a 190c that in the course of blowing the blade clutch

Customer Question

have a 190c that in the course of blowing the blade clutch wrapped the wire around the spindel, replaced blade clutch and wire/plug and the yellow pull switch but each time the switch is pulled and the blades start it trips auto-shutoff of engine
JA: Do you have fuel in the tank? If so, is the shut-off valve open and the fuel clean?
Customer: plenty of fuel, mower runs fine until i attempt to engage blades with switch, blades turn but only until engine stops, can find/override the safety shutoff
JA: Do you plan on doing the work yourself?
Customer: yes
JA: Anything else we should know to help you best?
Customer: how do i override the safety engine sutoff when blades are engaged?
Submitted: 2 months ago.
Category: Small Engine
Customer: replied 2 months ago.
Posted by JustAnswer at customer's request) Hello. I would like to request the following Expert Service(s) from you: Live Phone Call. Let me know if you need more information, or send me the service offer(s) so we can proceed.
Expert:  Wayne replied 2 months ago.

Hi I'm Wayne

I will help you with this

what you are describing when the wires wrapped around

spindle, they pulled and one is shorting against ground

need to pull them wires back a bit more and check for bare spot

I hope this helped you

Hi. If this helped you,

Please remember to rate my answer 3 or more stars.

I do not get paid for question, unless you rate my answer

If more info is needed, use the reply button -

NOT THE POOR/BAD SERVICE

Expert:  Wayne replied 2 months ago.

Hi

Just following up with you

did my answer help you

let me know, please

Wayne