How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask JohnF2015 Your Own Question
JohnF2015
JohnF2015, Small Engine Technician
Category: Small Engine
Satisfied Customers: 1079
Experience:  Owner/Service Technician at S & J Small Engines
87465640
Type Your Small Engine Question Here...
JohnF2015 is online now
A new question is answered every 9 seconds

Cannot pull apart the electrical quick connect on my lazer z

Customer Question

cannot pull apart the electrical quick connect on my lazer z clutch Model #LHP5223KC. Must be some kind on lock on it? Can you help
Submitted: 8 months ago.
Category: Small Engine
Expert:  JohnF2015 replied 8 months ago.

Hi, my name is***** will be assisting you.

There is a small locking tab on it that you will have to release. It can normally be done with a small flat tip screwdriver slipped under the tab which will cause it to release and then you can unplug the wiring.

Customer: replied 8 months ago.
I know what your talking about but this one is not like that
Expert:  JohnF2015 replied 8 months ago.

Are you attempting to disconnect at the clutch itself?

Customer: replied 8 months ago.
No sir.
Customer: replied 8 months ago.
No sir. Not for 24 dollars
Expert:  JohnF2015 replied 8 months ago.

The harness connector will have a small locking tab on it unless someone has changed it.

Customer: replied 8 months ago.
They usually have two tabs that slip under a band that you can push down and pull apart but this one has 1 tab but no band behind it
Customer: replied 8 months ago.
It's original
Expert:  JohnF2015 replied 8 months ago.

One band is original on this connection. The only other thing that I can suggest is that you try a side to side wiggle to get it to slip apart. If it has never been apart they can be hard to get loose. Sometimes even a small flat tip screwdriver inserted down through the opening in the connector to use a pry will help to release them and get them apart.

Customer: replied 8 months ago.
You still there?
Expert:  JohnF2015 replied 8 months ago.

Yes, I am.

Customer: replied 8 months ago.
Ok. I'm signing off. My bill is $18 dollars correct
Expert:  JohnF2015 replied 8 months ago.

Based on the information that I see. Yes, that is correct.

Thank you it has been a pleasure to assist you.

Please take a moment to rate your experience.