How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Curtis B. Your Own Question
Curtis B.
Curtis B., Technician
Category: Small Engine
Satisfied Customers: 12592
Experience:  have worked on and around most engine models for 35 yrs./Polaris ATV expert
30244710
Type Your Small Engine Question Here...
Curtis B. is online now
A new question is answered every 9 seconds

Cummins Onan RV QG4000 Model 4KYFA26100L will not start. Was

Customer Question

Cummins Onan RV QG4000 Model 4KYFA26100L will not start. Was running last weekend on camping trip got home won't start. Has inline gas filter, changed that, put in new gas pump and filter connect to it. Changed oil and air filter. Still will not run, starts to run then stops, like its not getting enough fuel.
Steve
Submitted: 4 months ago.
Category: Small Engine
Expert:  Hank F. replied 4 months ago.

Hello, my name is ***** ***** I am going to assist you with this.

Lets see what code is set in the controller.

Go to the genset and use the switch on the set itself.
Press 'Stop' 3 times within 5 seconds. The light in the switch will start flashing.
If the light flashes 3 times, pauses for 3 seconds, and flashes 3 more times, press and immediately release 'Stop' one more time.
This will put the controller into Fault Read Mode.
The light will flash (X) number of times, pause for 1 second, and flash for (X) number of times again. Count the flashes before and after the pause.
This will be the Fault Code.
Example: 2 rapid flashes, 1 second pause, 5 rapid flashes is a Fault Code 25.
There may be more than one Fault Code stored, so watch the light very carefully. If there is more than one code, it will display them all in order, and then start over again.

Be very careful not to misread a first level fault code (single digit code) as a second level fault code (double digit code).
The way to tell the difference is by the length of the pauses.
There is a 1 second pause between digits of a second level code, and a 3 second pause between codes.
For example, if it is flashing 2 times, 1 second pause, flashing 2 times, 3 second pause and repeating, then this is a second level fault code of 22.
If it is flashing 2 times, 3 second pause, flashing 2 times, 3 second pause and repeating, then this is a first level fault code of 2.

What Fault Code are you getting?
.

Expert:  Hank F. replied 4 months ago.

Have you checked the code yet?