How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Hank F. Your Own Question
Hank F.
Hank F., Technician
Category: Small Engine
Satisfied Customers: 14440
Experience:  Certified on Onan and Generac generators
Type Your Small Engine Question Here...
Hank F. is online now
A new question is answered every 9 seconds

Oman two cylinder generator air fuel adjust? Black plugs.

Customer Question

Oman two cylinder generator air fuel adjust ? Black plugs . Runs then cuts out.
Submitted: 3 months ago.
Category: Small Engine
Expert:  Hank F. replied 3 months ago.

Hello, my name is ***** ***** I am going to assist you with this.

There are many versions of the basic CCK engine, and not all of them are the same.

What is the full model number of your unit?

Customer: replied 3 months ago.
3cr / 1202 r. 5occk
Customer: replied 3 months ago.
Hank I am a low vision DAV one eye has an implant fixed for distance the other eye has a cataract from a service connected brain injury. Please be patient .
Customer: replied 3 months ago.
Definitely a down draft carb
Customer: replied 3 months ago.
Serial number is(###) ###-####
Expert:  Hank F. replied 3 months ago.

Not a problem - thank you for your service, fellow vet (Go Army!).

On this unit, the initial carb settings are as follows:

Idle needle - 1 to 1 1/4 turns out from lightly seated

Main needle - 1 1/4 to 1 1/2 turns out from lightly seated

I have uploaded the adjustment procedure for you.

Click here to download it.

Customer: replied 3 months ago.
Does the main fuel adjustment valve sit on top from the fuel line feed side?
Customer: replied 3 months ago.
I can not see it from the exposed side.
Customer: replied 3 months ago.
Expert:  Hank F. replied 3 months ago.

It depends on whether you have the Zenith carb or the Walbro.

The idle adjust is a screw that is on the back side.

On one of the carbs, the main adjust is a "T" nut right beside the idle screw.

On the other, the main adjust is a "handwheel" on the front of the carb.

Customer: replied 3 months ago.
Expert:  Hank F. replied 3 months ago.


Did you get the adjustment procedure?

Related Small Engine Questions