How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Wayne Your Own Question
Wayne
Wayne, Engine Rebuilder
Category: Small Engine
Satisfied Customers: 8426
Experience:  many years on egine rebuilding, lawn mower,roto tiller,Truck,and small engines
6825259
Type Your Small Engine Question Here...
Wayne is online now
A new question is answered every 9 seconds

Removal and replacement of ground drive belt . Z-Force S 48

Customer Question

Removal and replacement of ground drive belt . Z-Force S 48 wiith Kawasaki engine.
JA: I'll do all I can to help. Tell me a bit more about what's going on so we can help you best.
Customer: Drive belt worn out!
JA: Is there anything else important you think the Small Engine Technician should know?
Customer: Nothing. I just need to know the easiest way to replace it myself.
JA: OK. Got it. I'm sending you to a secure page on JustAnswer so you can place the $5 fully-refundable deposit now. While you're filling out that form, I'll tell the Small Engine Technician about your situation and then connect you two.
Submitted: 6 months ago.
Category: Small Engine
Expert:  Wayne replied 6 months ago.

Hi I'm Wayne

I will help you with this

You need to remove the PTO clutch and and drop the upper pulley down below the belt guards. Then put the belt on and re-install the pulley with the belt in place in the groove.

I hope this helped you

Hi If this helped you

Please remember to rate my answer 3 or more stars

If more info is needed, use the reply button

NOT THE POOR/BAD SERVICE