How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Curtis B. Your Own Question
Curtis B.
Curtis B., Technician
Category: Small Engine
Satisfied Customers: 26015
Experience:  have worked on and around most engine models for 35 yrs./Polaris ATV expert
30244710
Type Your Small Engine Question Here...
Curtis B. is online now
A new question is answered every 9 seconds

Do you have an actual picture of the transmission drive

Customer Question

Hi
Do you have an actual picture of the transmission drive that shows the belt routing for a LTR180 - I have the diagram but am struggling to get it to fit properly
Submitted: 1 year ago.
Category: Small Engine
Expert:  Curtis B. replied 1 year ago.
http://jdpc.deere.com/pimages/0002/0002040048____________A1.gif
Expert:  Curtis B. replied 1 year ago.
Here is LT180 instruction. But it does not have the extra two pulleys!
Expert:  Curtis B. replied 1 year ago.
http://outdoorpowerinfo.com/repairs/deere_lt160_auto_belts.asp
Customer: replied 1 year ago.
Thanks for the pictures Curtis. I think I had the belt routed correctly but it was making a bit of noise. On the LTR 180 the mid plate that holds the 2 pulleys is attached to the frame by a bolt (4,6,7,8) on the diagram. Does this come into contact with the belt or is it simply to hold the plate? Also it shows the bolt entering the front hole of the plate in the diagram - my plate seems to have markings for the rear hole that has a lower casing on the plate (does that make sense?)
Expert:  Curtis B. replied 1 year ago.
Simply to hold the bracket, the bolts should not touch the belt. Put the bolts back in the same holes that they were in!