How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Curtis B. Your Own Question
Curtis B.
Curtis B., Technician
Category: Small Engine
Satisfied Customers: 26026
Experience:  have worked on and around most engine models for 35 yrs./Polaris ATV expert
30244710
Type Your Small Engine Question Here...
Curtis B. is online now
A new question is answered every 9 seconds

I've got a 1996 John Deere 425 with Kawasaki 20HP motor. I'v

Customer Question

I've got a 1996 John Deere 425 with Kawasaki 20HP motor. I've got a starter that continues cranking even after releasing ignition key. I've replaced the ignition switch & module. (AM119974). Using test light seeing voltage at red wire feeding starter solenoid when key is switched to the crank position and also released to run position. With ignition switch is moved to off position no voltage present. This is same condition noted with units original ignition module. Any suggestion would be appreciated.
Thanks
Submitted: 1 year ago.
Category: Small Engine
Expert:  Curtis B. replied 1 year ago.
Welcome to JUST ANSWER small engines, let me try to help you !! Wiring schematic shows a relay between the key switch and the solenoid. If relay does not release, power stays on!------------------------------------------------------------------------------------------------------------------------------------------------------------------http://ww2.justanswer.com/uploads/koboma/2012-05-21_150612_deere_455_wiring.jpg
Customer: replied 1 year ago.
Ignition switch module includes a circuit board that has two micro relays on it. Don't believe that relay is causing my issue. That was reason I replaced ignition switch module. Believe the solenoid is getting feed from another source?
Expert:  Curtis B. replied 1 year ago.
http://ww2.justanswer.com/uploads/koboma/2012-05-21_150612_deere_455_wiring.jpg