How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Rick_LeShure Your Own Question
Rick_LeShure
Rick_LeShure, Technician
Category: Small Engine
Satisfied Customers: 29
Experience:  Consumer and Commercial Equipment Technician.
58033676
Type Your Small Engine Question Here...
Rick_LeShure is online now
A new question is answered every 9 seconds

Super z Have no power going to clutch. Have change

Customer Question

Hustler super z Have no power going to clutch. Have change out relays.
Submitted: 1 year ago.
Category: Small Engine
Expert:  Rick_LeShure replied 1 year ago.
its either the pto switch or the pigtail harness between the main harness going to the clutch if your fuses and relays are all good. make sure all wiring is good also. no breaks or pinches or rubs. with the key on someone in the seat and park brake off have a voltage meter in the two wires going to the clutch right at the clutch connector and check to make see you have battery voltage. if no voltage check the pigtail. it is a separate piece of the harness just to the clutch and has a diode inline. ohm test both wires in this pigtail after removing. it should have continuity both ways in one wire and continuity on one side on the other. if that is good and everything else is good (wiring fuses relays) replace the pto switch

Related Small Engine Questions