How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Curtis B. Your Own Question
Curtis B.
Curtis B., Technician
Category: Small Engine
Satisfied Customers: 26030
Experience:  have worked on and around most engine models for 35 yrs./Polaris ATV expert
30244710
Type Your Small Engine Question Here...
Curtis B. is online now
A new question is answered every 9 seconds

Need to get instruction on replacing drive belt on 4430 utility

Customer Question

need to get instruction on replacing drive belt on 4430 utility vehicle
Submitted: 1 year ago.
Category: Small Engine
Expert:  Curtis B. replied 1 year ago.
Welcome to JUST ANSWER small engines, let me try to help you !! You would need the Bush hog manual to get exact procedure. But this is much like all the ATV and UTV with the drive and driven clutches, with the single drive belt. First unhook your battery negative to kill the electrical. The the belt cover has to be removed, it may require removing brackets or other parts to get the cover off. With the cover off, the belt may be taken off just by rolling it over the driven pulley. If it is too tight, then the driven clutch is removed. A center bolt will be holding it to a spline d shaft. The drive clutch is on the tapered crankshaft and you do not want t remove it. With the driven clutch off, the belt can be removed or installed on both pulleys, then the driven clutch re-installed. That's all that is required.