How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask AppTech8579 Your Own Question
AppTech8579
AppTech8579, Home Appliance Technician
Category: Small Appliance
Satisfied Customers: 1649
Experience:  worked on appliances for around 15 years
76126576
Type Your Small Appliance Question Here...
AppTech8579 is online now
A new question is answered every 9 seconds

We have a Bissell 2070 quicksteamer powerbrush J04112 and it

Customer Question

We have a Bissell 2070 quicksteamer powerbrush J04112 and it has stopped letting the water come out, no water flow
JA: How long has this been going on? And how severe is the problem?
Customer: Stopped while being used. No water to clean with.
JA: Do you plan on doing the work yourself?
Customer: yes
JA: Anything else we should know to help you best?
Customer: Was cleaning perfectly until suddenly stopped letting water flow to cleaner brush.
Submitted: 10 months ago.
Category: Small Appliance
Expert:  AppTech8579 replied 10 months ago.

This would be the pump belt needing to be replaced.

Using the Star Rating Chart at the top of your page and rating me at least a 3 star is how I receive payment for helping you. Please if you do not understand my answer, don't hesitate to ask for more help. BONUSES appreciated.

Customer: replied 10 months ago.
This model does no have a pump belt. the Model is J04112
Expert:  AppTech8579 replied 10 months ago.

Im not pulling that model number up

Expert:  AppTech8579 replied 10 months ago.
  • Please check the water level in the tank. It is imperative that the water level be at the full line when beginning your cleaning. Because this machine is gravity fed; if the water level drops too low, there will not be enough pressure to release the fluid.
  • Please make sure that the siphon tube for the autoload insert (on the water tank) is perfectly aligned with the front and back of the tank. If the tube is turned to the right side or the left side of the tank the unit will not spray.
  • Please check the vent hole on the tank. This hole is clearly marked and the water level must not be above this hole. The vent hole must also be clear.
  • Please check the spray bar on your machine. The spray bar is removable so you may take this off if desired and inspect the spray holes to ensure that they are clear.
  • Try removing and reinstalling the handle/screw assembly. The trigger mechanism is contained inside the handle. Occasionally it is possible for this part to become misaligned. To check for proper handle installation, try turning the handle from side to side and try to pull the metal part of the handle up or down....if properly installed neither of the previous actions should be possible.

If these suggestions do not solve the problem, please take your machine to a BISSELL Authorized Service Center for inspection.