How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Dan Your Own Question
Dan, Technician
Category: Saturn
Satisfied Customers: 23473
Experience:  Independent Shop Experience, 2 Year Automotive Diploma, & Access to Information Database
Type Your Saturn Question Here...
Dan is online now
A new question is answered every 9 seconds

Code P1682 still on after replacing ignition switch. Limps

Customer Question

Code P1682 still on after replacing ignition switch. Limps home and is a danger
JA: Has the car been stalling out?
Customer: Engine shakes but no stall just super slow
JA: What is the model/year of your Saturn?
Customer: 2008 saturn aura XE
JA: Are you hoping to fix this yourself? What have you tried so far?
Customer: 2.4
JA: Anything else you think the mechanic should know?
Customer: Car had ignition switch replace and new spark plugs I'm trying to know if a bad ground or ECM. Too complicated of a car
Submitted: 1 month ago.
Category: Saturn
Expert:  Dan replied 1 month ago.

Hello, my name is***** usually means the fuse box under hood has failed, it is a common problem. Check for blown PCM/ECM fuse or ECM/TRANS fuse. Check for Ignition 1 voltage at Engine Control Module (ECM) connector C2 terminal 34. If no voltage, check powertrain relay power and control circuits. Check for Ignition 1 voltage at ECM connector C1 terminal 28. If no voltage, check run/crank relay power and control circuits. If low voltage at pin 28, check the Underhood Electrical Center (UHEC) connector C5 pin B3. If connectors are good but voltage is low replace the fuse box/UHEC. Let me know if you have more questions, thanks.

Customer: replied 1 month ago.
Dan, thanks, ***** ***** need a bit of further guidance. Which fuse nbrs are those for pcm/ecm and pcm/trans? Do I actually unplug the connector to take the measurements at C2 terminal 34 or do I take measurements off the fuse box. I do see two big plugs to ecm those are c1 and c2 right? But if so what is connector C5? Thanks!
Customer: replied 1 month ago.
Dan can you tell me what C1, C2, C5 terminals mean? Thanks
Customer: replied 1 month ago.
Posted by JustAnswer at customer's request) Hello. I would like to request the following Expert Service(s) from you: Provide Diagrams, Manuals, or Instructions + Local Mechanic Recommendations. Let me know if you need more information, or send me the service offer(s) so we can proceed.
Expert:  Dan replied 1 month ago.

You can check with ECM and UHEC plugged in, just backprobe wiring. Here is connector diagram of each.



Customer: replied 1 month ago.
Thanks, ***** ***** first Dropbox file for the ECM connector? If so, that file was empty.
Expert:  Dan replied 1 month ago.

Yes it was, give me a minute and I"ll fix. >Thanks.

Expert:  Dan replied 1 month ago.

It should work now. Thanks.

Related Saturn Questions