How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Pete Your Own Question
Pete, Saturn Mechanic
Category: Saturn
Satisfied Customers: 24137
Experience:  17 years Saturn Technician experience.
Type Your Saturn Question Here...
Pete is online now
A new question is answered every 9 seconds

2003 Saturn Vue: a passenger front wheel..Front Wheel Drive..cyl

Resolved Question:

Step by step how to replace a passenger front wheel bearing on my 2003 Saturn Vue Front Wheel Drive. 4 cyl.
Submitted: 5 years ago.
Category: Saturn
Expert:  Pete replied 5 years ago.
Hello,I will be glad to try and assist you with this,Welcome to Just Answer.


I apologize as I don't have any pictures to post on this but here is the step by step instructions you are requesting for this procedure to replace the wheel bearing:

1. Remove Front Brake Rotor.
2. Disconnect wheel speed sensor electrical connector (if equipped).
3. Remove electrical connector from connector bracket.
4. Remove front wheel drive axle nut.
NOTICE: Be careful not to allow drive axle boot to contact any part of vehicle. Contact may cause the boot to rip requiring boot replacement.
5. Suspend or support drive axle from strut spring with mechanics wire.
6. Remove and discard wheel bearing/hub bolts.
NOTICE: Never pull on the shaft assembly. If difficulty is encountered in separating axle from hub, tap on end of drive axle shaft using a block of
wood and a hammer. Do not hammer directly on end of axle.
7. Remove wheel bearing/hub assembly and shield.
NOTICE: During wheel bearing installation drive shaft splines must line up with wheel bearing splines. Failure to do so will damage wheel bearing
hub and axle shaft assemblies.
IMPORTANT: Do not tighten fastener at this time.
1. Install wheel bearing/hub assembly and shield onto shaft.
2. Install wheel bearing/hub to knuckle bolts.
Wheel Bearing/Hub-to-Knuckle Bolts: 130 Nm (96 ft. lbs.)
3. Install drive axle shaft nut.
Front Axle-to-Knuckle Nut: 205 Nm (151 ft. lbs.)
4. Install wheel speed sensor electrical connector to bracket (if equipped).
5. Connect wheel speed sensor electrical connector.
6. Install front brake rotor.

Let me know if you need anything else,click accept if you feel satisfied with your answer as this is how I get credited for my time,Thanks Pete!
Pete and other Saturn Specialists are ready to help you

Related Saturn Questions