Hello
Here is the procedure for you. Its best to just replace the axle with a rebuilt unit that has rebuilt joints.
If you have further questions on this, please feel free to reply.
Master Tech
30 years/Master Tech. Foreign and Domestic
Sorry for the delay,,
Which end?
Which side?
What you can do is take the nut and put it back on the end of the joint, but only thread it on untill the end of the nut is flush with the end of the joint, then take a BIG hammer and drive it inward, you may reach a point to where it cant go any further because the nut in hitting,,,then just remove the nut and use a center punch to drive it the rest of the way.
Just be carefull not to damage the threads on the axle,,,,they might charge you for the core when you exchange it for a rebuilt unit.
Good luck man!
Thanks for asking!