Answer

Here is the way to relearn this system. Let me know how you make out.

Turn the ignition lock cylinder to the RUN position.

Start the engine in order to verify that the system operates correctly.

Observe if the SECURITY indicator lamp:

•	If the lamp turns ON for about 5 seconds and then turns OFF, the programming of the new theft deterrent module is successfully completed.

•	If the lamp flashes at a rate of 1 flash per second (or until the ignition switch is turned to the OFF position) and the engine starts, the programming is not complete. The theft deterrent module did not store the resistor pellet code.

•	Inspect for the following conditions before you repeat the programing procedure:

-	The theft deterrent module connector has poor terminal contact.

-	The ignition lock cylinder circuits have opens, shorts to battery, or shorts to ground

-	The resistor sensing contacts are faulty.

-	The ignition key resistor pellet is faulty.

Expert:	Carhelp4u
Pos. Feedback:	99.8 %
Accepts:
Answered:	10/13/2007

ASE CERTIFIED TECH

ASE CERTIFICATION