JustAnswer
>
Car
Ask A Question
|
Register
|
Login
|
Help
Car
Ask a Car Question, Get an Answer ASAP!
Have your own Car question?
10 Auto Mechanics are Online Now
characters left:
Not a Car Question?
Question
I recently installed a complete OEM cruise control system on my 2000 Jeep Cherokee Sport. I followed all installaton steps yet it is still not working. It does not even appear that the unit is turning on. Any ideas on where to start???
Submitted: 1053 days and 14 hours ago.
Category: Car
Value: $9
Status: AWAITING EXPERT REPLY
+
Read More
Optional Information
Optional Information:
2000 Jeep Cherokee Sport 4.0L
Already Tried:
ensured all plugs are connected to the clock spring, cruise buttons, and servo.
Posted by
JONATHAN
1052 days and 21 hours ago.
Info Request
are the installation instructions included in the kit and come from Jeep? were there any fuses that needed to be installed? do you have access to a multimeter and a scan tool?
1052 days and 19 hours ago.
Reply
Reply to JONATHAN's Post: I started to tinker around with this problem again. I found that there was no input being received by my PCM. The Jeep instructions I received were aparantly for models that had cruise control from the factory. Mine did not, so I had to switch two wires around so the PCM would get the proper signal. Thanks for the help though...you were on the right track!
+
Read More
Related Car Questions
Once my car gets down to about half a tank of fuel, the revs
i have a 96 mazda mx6 2.5 v6 with the auto tranny. i drive
I have a 2000 Hyundai Elantra with a coolant leak somewhere....
Is it possible to epoxy an aluminum cast engine block?
I have an Acura Tsx (2004) and had some corrosion on my batt...
Is it possible to install gullwing doors on a 1999 Mitsubish...
I have a 2005 Kia Optima, and I was driving it and it sounde...
03 discovery v8 knoking after fast idel com off & even if I