we have a Linotype Linotronic 530 and had an engineer upgrade our RIP to a level 3 Harlequin (from level 2) he sent in a calibration (directly from the PC the rip is installed in) which was nealy 9" in width, now if we try and send in any job larger than 9" it chops all info off past this mark. Spoke to engineer about this problem and he said that the Lino has set itself to output at only 9" rather than it's usual 18". My question is this: How do I change the output size from 9" to 18" (we have never needed to to do this before and thats why I'm asking this question!) Many Thanks - I hope you can help me! cheers alan