Answer

You are about to find out why it costs so much to replace.Make sure you replace it with an AC Delco so you don't have to do it again right away.

Generator Replacement

Removal Procedure

Caution: Before servicing any electrical component, the ignition and start switch must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.

1. Disconnect the negative battery cable.
2. Remove the accessory drive belt.
3. Remove the upper front bolt.
4. Remove the radiator.
5. Raise and suitably support the vehicle.
6. Remove the front engine splash shield.
   

   	View Full Image

   
   
   
7. Loosen the rear generator bracket from the engine.
8. Remove the top bolt.
9. Remove the front lower mounting bolt.
10. Remove the lower rear mounting bolt.
11. Remove the upper rear mounting bolt.
12. Remove the duct from the back of the generator.
13. Disconnect the following electrical connections:
    <> <> < vAlign=top> - < vAlign=top>Regulator
    <> <> < vAlign=top> - < vAlign=top>Battery output
    <> <> < vAlign=top> - < vAlign=top>Heated windshield (if equipped).
14. Remove the front generator/ A/C bracket.
15. Rotate the generator and remove.

Expert:	Davo
Pos. Feedback:	99.4 %
Accepts:
Answered:	6/30/2006

Master technician

ASE Master Technician/Advanced Automotive Diagnostic Technician