Accepted Answer

Hi There,

In order to replace the lamp:

1) Loosen the screw on the lamp cover, you should then be able to remove the lamp cover.

2) You should see two wires and a connector, you should be able to disconnect the connector from the chassis.

3) You will then need to loosen the single screw inside, that affixes the lamp to the projector. Becareful with this, its very easy to drop the screw inside.

4) You should then be able to gently pull the lamp upwards to remove it.

In order to install the new lamp, do exactly the same but in reverse.

Once you have installed the new lamp you will have to reset the lamp counter, in order to do this :

i. Press and hold the EXIT button on the projector for 5 seconds to display the total used lamp time.

ii. Press AUTO on the projector to reset the lamp hours to “0”.

iii. Wait about 5 seconds to let the OSD disappear.

Hope this helps

James

Expert:	James
Pos. Feedback:	100.0 %
Accepts:	338
Answered:	11/10/2009

Technician

4 Years as a Audio Visual Service Engineer